X207 G2 Spring Counterbalance Installation

Roll Tube in Header Assembly

Counterbalance Assembly

Metal Washer

Spring Mounting Plate

Flanged Nuts (3)

Connecting Pin with Clip

Alignment Tab and Grooves

Slide the Metal Washer onto the Shaft

Align the Holes of the Mounting Plate Flanges

with the Hole in the Tube of the Counterbalance Assembly.

Slide the Pin through the Holes.

Fasten Clip to retain the Pin.

Align the Groove on the end of the Counterbalance

with the Tab inside of the Roll Tube.

Slide the Counterbalance Assembly into the Tube.

Align the second Hub Groove

with the Tab on the Roll Tube

then fully insert the Counterbalance Assembly.

Fasten the three Flanged nuts securely

to the Studs on the Header Mounting Bracket.