-
-
READ THESE INSTRUCTIONS CAREFULLY. OBSERVE WARNINGS AND PRACTICE CAUTION WHEN INSTALLING, OPERATING, OR MAINTAINING YOUR GOFF’S DOOR ASSEMBLY.
-
WARNING: Damage to the Controller by an un-Certified Electrician will NOT be covered under Goff’s Warranty.
-
DO NOT USE AN IMPACT DRIVER TO MANUALLY OPERATE THE MOTOR AS IT MAY SHEAR OFF THE 13MM OUTPUT SHAFT.
-
Regardless of the available Input Power, Goff’s High Performance Doors are supplied with a 3-Phase Motor.
-
The Control Panel will internally “transform” the specified Input Power (from your order) into the appropriate 3-phase Output Power.
-
If only 110V Power is available then a Step-Up transformer will be required.
-
-
-
Unpack the Transformer.
-
Check the Information Plate to verify the correct Transformer Input and Output Voltages. "120V to 240V"
-
Mount the Transformer as needed so that Incoming Power can be brought to it, and Outgoing Power can be sent to the Control Panel previously Installed.
-
-
-
Open the Door to access the Wiring Harness.
-
Locate the Wire bundle marked with "X" Conductors.
-
Locate the Wire bundle marked with "H" Conductors.
-
-
-
Make the following Input Connections.
-
H1 - Hot/Line (120VAC)
-
H2 - Fasten together with H4 and Neutral
-
H3 - Fasten together with H1 and Hot/Line
-
H4 - Neutral
-
-
-
Make the following Output Connections.
-
X1 - Hot/Line. Terminates in L1 inside the control panel
-
X2 & X3 - Fasten together
-
X4 - Neutral. Terminates in L2 inside the control panel
-
240VAC is measured between X1 and X4.
-
Make sure Power is OFF while Wiring the Motor to the Control Panel in the following steps.
-
Team
