X073 G2 Face Mount External Motor Installation

Remove two M8 Bolts from the Motor Housing side, noting their location.

Orient the Torque Bracket with the Slot up.

Loosely reinstall the M8 Bolts with the Torque Bracket between the Motor and the Bolts.

Insert the Shaft Key into the Keyway groove of the Shaft.

Slide the Motor onto the Shaft until the Torque bracket touches the aluminum Extrusion.

Install the Hex Bolt through the Torque Bracket and into the aluminum Extrusion.

Fully tighten the M8 Bolts in the Motor Housing.