Strip Door Frame (Lightweight)

The Base and Beam are oriented toward the Frame Front

Bolt the Bases to the Posts (Aligned Flush to Front).

Bolt the Beam to the Posts.

Erect the Frame Structure.

Level and Secure Frame Structure to the Floor.

Bolt the Supports to the Posts.

Plumb the Frame.

Secure the Supports to the Floor.

Orient the Flush face of the Post with the Flush face of the Base.

Insert the Post into the square hole in the Base.

Install the bolts from the Frame Inside

through the Post

through the Base Flange.

Square the Post to the Base.

Secure them with a Lock Nut.

Slide the Beam

between the Tabs on the Post Top.

Insert Bolts from the Front of the Frame.

Secure the pack with Lock Nuts.

Move the Frame Structure to it's Installation Location.

Level, Square and Plumb the Structure.

Anchor the Frame Structure to the Floor.

Supports Bolt to the Outside of the Frame Structure Posts.

With the Frame Plumb (Front to Back)

rest the Support's Floor Mounting Flange on the Floor

Bring the Mounting Angle of the Support to mate with the Outside Face, and the Rear Face of the Post

Bolt the Support to the Post.

Secure the Support to the Floor.

Repeat for the remaining support(s).

Align the Edge of the First Section of Track

with the Inside Face of the Post.

Align the Bottom Edge of the Track to the Bottom Edge of the Beam.

Check for Level.

Secure the First Section of Track to the Beam.

Butt the Second Section of Track up to the Edge of the First, then secure it to the the Beam.

The Last section of Track can be cut to the fill the remaining length to the other Post. (Cut the outermost end.)