Re-Homing Limits on MGM Control Panel

Look at the Status Bar on the Top Edge of the Touchscreen. It should Read "Home System".

To Home the System, we only need to tell the Encoder where the Floor/Close Limit is.

It will then Remember how far it has to Travel from there, to Reach the Open Limit.

Tap the SETUP AND DIAGNOSTICS Button.

Tap the SETUP Button.

Note, if Password Protection is Setup on your Control Panel, you will next be asked to Enter the Password.

Finally, Tap the QUICK SETUP Button.

Use the Close Button to Jog the Door to the Desired Closed Position.

Once there, Press and Hold the HOME SYSTEM Button.

Hold the HOME SYSTEM Button until the "A/D Door Position" and "Actual Door Position" values Jump to Zero.

Press the MAIN SCREEN Button to Return to the Home Screen.

The Status Bar on the Top Edge of the Touchscreen should now Read "System Ok".

The Door should now Run in its Original/Previously set Limit Range.