Mount G1 STD Roll Header Assembly

Use two (2) people, and two ladders (at minimum).

Raise the Roll Header Assembly into place on the wall.

The Bottom and Outside edges of the Header Bracket Mounting Flanges should fit inside of Marks on the Mounting Surface.

Transfer the (3) Slot locations, per side, onto the Mounting Surface.

Prepare the locations for Hardware appropriate to the building material.

Loosely secure with three (3) sets of mounting hardware per side.

Level the Header Assembly, and fully tighten all six sets of hardware.

At this point leave the Door/Web Roll tied off and held in place as it comes.