Skip to main content

v1.0

Major VersionM

by Trent Borgardt

  1. Use two (2) people, and two (2) Ladders at minimum to Install the Roll Header Assembly Raise the Roll Header Assembly into place on the Projection Brackets.
    • Use two (2) people, and two (2) Ladders at minimum to Install the Roll Header Assembly

    • Raise the Roll Header Assembly into place on the Projection Brackets.

    • Loosely Tighten with three (3) sets of ΒΌ-20 Screws, Flat Washers and Hex Nuts per side.

    • Do not fully tighten the Hardware until the Header Assembly Brackets are Aligned and Plumb with the Projection Brackets.

    • Check the Header Assembly for Level, and make any necessary final Adjustments.

    • Once aligned, fully Tighten all six sets of Hardware.

    • At this point leave the Roll/Web Assembly tied off and held in place as it comes.

Finish Line

Trent Borgardt

Member since: 03/01/2022

3,615 Reputation

57 Guides authored

Team

Engineering Team Member of Engineering Team

3 Members

83 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 35