Skip to main content

v1.1

Minor Versionm

by Trent Borgardt

  1. Place the Door Header onto a Flat Work Surface as Shown. Using a 1/2in Socket, Remove the 3 Nuts holding on the Bearing Plate.
    • Place the Door Header onto a Flat Work Surface as Shown.

    • Using a 1/2in Socket, Remove the 3 Nuts holding on the Bearing Plate.

    • Remove the Washers and Lock Washers underneath each Nut.

    • Repeat on the opposite side of the Header.

    • Once you Remove the Bearing Plates, the Roll Tube will be able to move freely, so take care to not Pinch/Crush Fingers or Hands.

    • Having someone to support the Roll Tube on each Side will help tremendously.

  2. With the Bearing Plates Removes, you will be able to Pull the Shaft Assemblies out of the Roll Tube. Swap the Shafts. When sliding the Shaft Assemblies into the respective ends, ensure that the Heads of the Screws on the Outer Hubs are fully seated against the Roll Tube.
    • With the Bearing Plates Removes, you will be able to Pull the Shaft Assemblies out of the Roll Tube.

    • Swap the Shafts.

    • When sliding the Shaft Assemblies into the respective ends, ensure that the Heads of the Screws on the Outer Hubs are fully seated against the Roll Tube.

    • Replace the Bearing Plates.

    • Replace the Washers, Lock Washers, and Nuts to Secure the Bearing Plate to the Header.

Finish Line

Trent Borgardt

Member since: 03/01/2022

3,495 Reputation

55 Guides authored

Team

Engineering Team Member of Engineering Team

3 Members

81 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 2

Past 30 Days: 3

All Time: 44