-
-
Use two (2) people, and two ladders at minimum to Install the Roll Header Assembly
-
Raise the Roll Header Assembly into place on the Projection Brackets.
-
Loosely tighten with three (3) sets of ¼-20 screws and hex nuts per side.
-
Do not fully tighten hardware until the Header Assembly Brackets are aligned with the Projection Bracket’s edges.
-
Check the Header Assembly for level, and make any necessary final adjustments.
-
Once aligned, fully tighten all six sets of hardware.
-
At this point leave the roll assembly tied off and held in place as it comes.
-
Almost done!
Finish Line
Team
