G1 Premium Fall Guard In-Jamb Door

Technical Support Contacts:

Phone: 262-746-3374

Email: techsupport@goffscw.com

Website: http://www.goffsenterprises.com

The Door Header must be level for the Door to operate properly.

Check the door opening Header for level, and adjust the installation accordingly.

Locate the Left Hand Header Mounting Bracket, and prepare to work on the upper Left of the Door Opening.

Viewed from Back Surface.

Align the top edge of the Bracket to the upper surface of the Door Opening.

Align the back edge of the Bracket to the Back Edge of the Door Opening.

Measure the Hole Centers on the Bearing Block to help determine which Mounting Holes will be used in the Bracket.

Transfer Four Hole locations onto the Mounting Surface.

Prepare the Mounting Surface for Wall Mounting Hardware.

Insert your Wall Mounting Hardware through Idler Bearing assembly (3 pieces).

Then through the Left Hand Header Mounting Bracket, into the Mounting Surface.

Viewed from Back Surface.

The Door Header must be level for the Door to operate properly.

Locate the Right Hand Header Mounting Bracket, and prepare to work on the upper Right of the Door Opening.

Align the top edge of the Bracket to the upper surface of the Door Opening.

Align the back edge of the Bracket to the Back Edge of the Door Opening.

Transfer Three Hole locations onto the Mounting Surface.

Prepare the Mounting Surface for Mounting Hardware.

Mount the Header Mounting Bracket to the Mounting Surface.

Use 2 people, and 2 ladders at minimum.

Raise the Header Assembly

Insert the Idler Shaft into the installed Idler Bearing Assembly at Upper Left.

At the right side, orient the Switches toward the Front.

Insert the Upper Motor Peg fully into upper hole of R.H. Header Mounting Bracket.

Slip the plastic Ring onto Lower Motor Peg.

Insert the Lower Motor Peg into the Lower hole on the Header Mounting Bracket.

Insert the plastic Clip onto the Upper Motor Peg to fill space between the Bracket and Motor.

Align Track to the Header Bracket.

Transfer and prepare Track Mounting Hole locations.

Install Bolts and Spacers in Top two Track holes.

Temporarily Install Fall Guard Bracket at Bottom.

Install five additional Bolts on Bottom Bracket (outside of Track).

Plumb the Track.

Securely fasten all hardware.

Use two people to make this process easier.

Align the mating surfaces of the Track Transition Bracket -

-to the Header Mounting Bracket.

Plumb Track Assembly (Front to Back).

Transfer six Track Mounting Hole locations onto the Mounting Surface.

Prepare the Hole locations for the Mounting Hardware.

Move the Track back into place.

Partially thread a Bolt through the top hole of the Track into the Mounting Surface.

Slide a Spacer-

-between the Track and the Mounting Surface to space the Track away from the wall.

The Spacer Flange should rest against the Back Surface of the Track.

Loosely thread a Bolt in the Second hole from the Top of the Track.

Insert a Spacer between the Track and the Mounting Surface at the second Hole.

From the Back, slide the Bottom FG Bracket between the Track and the Mounting Surface.

The Fall Guard Brackets should be oriented so that the Flange reinforces the Rear of the Track.

Loosely thread four Screws through the Track

through the Slots of the Fall Guard Bracket

into the prepared holes in the Mounting Surface

Plumb the Track Front to Back.

Ensure that all three Brackets fit tightly against the Back of the Track.

Snugly tighten all six Screws.

Mark and prepare 5 holes for the Bottom Fall Guard Bracket.

Install five Screws through the FG Bracket to the wall.

Plumb the Track.

Fully tighten all 11 Bolts

Repeat for the other Track Assembly