-
-
Tracks are marked for orientation as Left Side, and Right Side.
-
Lay the two Vertical Track Assemblies on your work surface.
-
Un-roll the Side Seal material.
-
Remove the Plugs from the front of the Track
-
Locate the Track Projection Mount Brackets, four (4) per Track.
-
Locate four the ΒΌ-20 Screws and Flanged Nuts.
-
-
-
Push a screw through the hole in the back surface from the inside of the Track.
-
Slip the Projection Bracket onto the 1/4-20 Screw, with the hole facing the Track, and then thread the nut, onto the screw.
-
The slotted end of the Projection Bracket will fasten to the Mounting Surface in a later step.
-
These Brackets should be Mounted so that their Flanges point Vertically (as shown).
-
Fully tighten the hardware for these brackets once they are aligned with the Track edges.
-
Re-install the Plug Caps into the hardware access holes on the front side of the Tracks.
-
Team
