Skip to main content

v1.0

Major VersionM

Approved Installation Instruction Approval Process

by Trent Borgardt

  1. Technical Support Contacts:
  2. The Door Header must be level for the Door to operate properly.
    • The Door Header must be level for the Door to operate properly.

    • Check the door opening Header for level, and adjust the installation accordingly.

    • Locate the Left Hand Header Mounting Bracket, and prepare to work on the upper Left of the Door Opening.

    • Align the top edge of the Bracket to the upper surface of the Door Opening.

    • Align the back edge of the Bracket to the Back Edge of the Door Opening.

    • Measure the Hole Centers on the Bearing Block to help determine which Mounting Holes will be used in the Bracket.

    • Transfer two hole locations onto the Mounting Surface.

  3. Prepare the Mounting Surface for Wall Mounting Hardware.
    • Prepare the Mounting Surface for Wall Mounting Hardware.

    • Insert your Wall Mounting Hardware through Idler Bearing assembly (3 pieces).

    • Then through the Left Hand Header Mounting Bracket, into the Mounting Surface.

  4. After Mounting the Drive-Side Bracket (by-itself) directly into the Jamb, Use 2 people, and 2 ladders at minimum.
    • After Mounting the Drive-Side Bracket (by-itself) directly into the Jamb, Use 2 people, and 2 ladders at minimum.

    • Raise the Header Assembly

    • Insert the Idler Shaft into the installed Idler Bearing Assembly at Upper Left.

    • At the right side, orient the Switches toward the Front.

    • Insert the Upper Motor Peg fully into upper hole of R.H. Header Mounting Bracket.

    • Slip the plastic Ring onto Lower Motor Peg.

    • Insert the Lower Motor Peg into the Lower hole on the Header Mounting Bracket.

    • Insert the plastic Clip onto the Upper Motor Peg to fill space between the Bracket and Motor.

  5. Locate the Left Hand Track (Marked LH).
    • Locate the Left Hand Track (Marked LH).

    • Align the mating surfaces of the Track Transition Bracket -

    • -to the Header Mounting Bracket.

    • Plumb Track Assembly (Front to Back).

    • Use a 2nd Person to hold the Track in place.

    • Transfer the Mounting Hole locations onto the Mounting Surface.

  6. Prepare the Hole locations for the Mounting Hardware.
    • Prepare the Hole locations for the Mounting Hardware.

    • Check for Plumb before securing the Track tightly to the Mounting Surface.

    • Repeat process for the other Track assembly.

  7. The Valance Assembly Mounts on top of the bent Flanges of the installed Header Mounting Brackets.
    • The Valance Assembly Mounts on top of the bent Flanges of the installed Header Mounting Brackets.

    • The Valance Beam has pre-installed Mounting Hardware.

    • Remove two Screws from the Valance Beam.

    • Leave the Nuts in the groove near the ends.

    • Lift the Beam into place on top of the Flanges.

    • With a Screwdriver, move the Nuts into place above the Mounting Flange holes.

    • Re-install the Screws through the hole in each Mounting Flange, then secure them in the captured Nuts.

Finish Line

Todd Lucas

Member since: 03/01/2022

13,056 Reputation

127 Guides authored

Team

Engineering Team Member of Engineering Team

3 Members

83 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 8

All Time: 98